Fault Code - VALBERG WF 1014 B W180C3 Instrucciones De Uso

C C
Informations pratiques Useful information

Fault code

The washer stops when the program is running. The display window shows fault code «F01»,
«F03», «F13», «F14», «F24», else fault codes from «F04»to «F98» or «Unb».
Fault Code List
Displayed on Display Window
"F01"
"F03"
"F13"
"F14"
"F24"
else fault code, "F04-F98"
"Unb"
«F01» displayed on screen
The machine is not fed with water or insufficient water. Check:
• Faucet is fully open and has enough water pressure.
• Water inlet pipe is knotted or not.
• Filtering net of water inlet pipe is blocked or not (refer to maintenance and repair).
• Water pipe is frozen or not.
Press «Start/Pause» key after fault is removed.
If fault occurs again, please contact with after-sale service (refer to after-sale service.).
«F03» displayed on screen
The washer is not emptied. The washer stops the program being executed. Shut down the
machine and disconnect power supply. Check:
• Drain pipe is knotted or not.
• Filter in drain pump is blocked or not (refer to the cleaning of filter in drain pump)
IMPORTANT
Ensure that the water has cooled before draining the
appliance.
40 40
Fault Description
Water inflow fault
Drainage fault
Door lock fault
Door unlock fault
Overflow or too much foam.
Electronic module fault.
Unbalance alarm
EN FR
C C
Useful information Informations pratiques
• The drain hose is frozen up.
Plug in the appliance again.
Select and start the «Spin « program or push the «On/off « button for at least 3 seconds and
restart the desired program.
If the fault occurs again, please contact After-Sales Service (see «After-Sales Service»).
If fault code «F13» is shown
Door lock is abnormal. Start program for 3 times to check whether the door is closed.
Open or close it again.
After fault is removed, press «Start/Pause» key. If fault occurs again, disconnect power supply
and contact with after-sale service.
If fault code «F14» is shown
Door open fault.
Action: Press «Start/Pause» button. The washing machine will try to open the door.
The alarm will not be removed until the door is unlocked. Or, press the «On/Off» button to
restart the washing machine, and the alarm will be removed.
If fault code «F24» is shown
Water level reaches overflow level.
Remove it by pressing «Start/Pause « button and drain away water.
Select and start required program. If fault occurs again, disconnect power supply and contact
with after-sale service.
If else fault code «F04» to «F98» is shown
Electronic module fails.
Press the «On/off « button for 2 seconds to turn off the machine.
After fault is removed, press «On/off « button. If fault occurs again, disconnect power supply
and contact with after-sale service.
If fault code «Unb» is shown
Unbalance alarm shall be solved by the following methods.
1. Laundry winding.
Press the «On/Off « button for 2 seconds for shutdown, open the door, shake the clothes and
put them back into the washing machine, then select the spin program to dry again.
2. Too light-weighted laundry.
Press the «On/Off « button for 2 seconds for shutdown, open the door, put in one or two towels,
and then select the spin program to dry again.
41 41 EN FR