Environmental Protection - ST 526 A Manual De Instrucciones

the engine, remove the key, wait the moving
parts stop, and carefully inspect the machine to
check there is no damage. Vibrations are
normally synonymous with a problem. Repair
any damage before re-using the machine.
• Before leaving the machine, disconnect all the
commands and remove the ignition key from its
slot on the machine.
• Before
carrying
inspections or adjustments, switch off the
engine, remove the key and wait the moving
parts stop (unless otherwise indicated in the
instructions). Disconnect the cable on electric
motors. (Optional).
• Do not touch the engine parts which heat up
during use. Burns hazard.
• Never operate the snow thrower at high
transport speeds on slippery surfaces. Use
care when reversing. Look behind you to make
sure there are no obstacles before and during
operations in reverse gear.
• Disengage power to the auger when snow
thrower is transported or not in use.
• Always be sure of your footing, and keep a firm
hold on the handle. Walk never run.
Use limitations
• Do not use the machine sideways on a slope.
Always move from top to bottom, then from
bottom to top. Exercise caution when changing
direction on a slope. Avoid steep slopes.
• Do not use the machine if the guards are
insufficient or if the safety devices are not
correctly positioned.
• Never disengage or tamper with the safety
systems.
• Do not alter the engine adjustments, nor over-
run it. If the engine is forced to work with an
excessive number of rotations, the risk of
personal injury increases.
• Do not overload the machine by driving it too
fast.
• Do not place hands inside the chute or the
auger without firstly switching off the engine
and removing the key.
2.4 MAINTENANCE,
TRANSPORT
Ensure regular maintenance and correct storage
to maintain machine safety.
Faulty or worn-out parts must always be
replaced and never repaired. Only use original
spare parts: the use of non-original and/ or
incorrectly fitted parts will compromise the
safety of the machine, may cause accidents or
personal injuries for which the Manufacturer
is under no circumstance
responsible.
out repairs, cleaning,
STORAGE
liable
Maintenance
• If the fuel tank has to be drained, this should be
done outdoors and when the engine is cool.
• To reduce the risk of fire, regularly check the
machine for oil and/or fuel leaks.
Storage
• Do not leave fuel in the tank if the machine is
stored in a building where fuel vapours come in
contact with the open flame, sparks or heat
sources.
• Let the engine cool down before storing the
snow thrower indoors.
• Always refer to owner's guide instructions for
important details if the snow thrower is to be
stored for an extended period.
Transport
• If the machine must be transported on a truck
or trailer, use ramps with suitable resistance,
width and length.
• Load the machine with the engine switched off
and pushed by an adequate number of people.
• During transport, close the fuel cock (if there is
one) and adequately secure the machine to the
means of transport using cables or chains.

2.5 ENVIRONMENTAL PROTECTION

Safeguarding the environment must be a relevant
and priority aspect of machine use, of benefit to
the community and the environment we live in.
• Avoid
neighbourhood.
• Adhere
governing the disposal of packaging, oil, fuel,
filters, damaged parts or any other element
which may have an impact on the environment;
this waste should not be disposed of along with
standard household waste, but must be
disposed of separately and sent to special
waste disposal facilities for handling and
recycling.
• When the machine is withdrawn from service,
do not dump it in the environment, but take it to
AND
a waste disposal facility in accordance with the
local regulations in force.
or
EN - 3
being a disturbance
strictly to the local
to the
regulations