Unpacking; Assembly - Power Stroke PS80979B Manual Del Operador

UNPACKING

This product requires assembly.
 Carefully cut the box down the sides then remove the
tool and any accessories from the box. Make sure that
all items listed in the packing list are included.
WARNING:
Do not use this product if any parts on the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
NOTE: This tool is heavy. To avoid back injury, lift with
your legs, not your back, and get help when needed.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-877-617-3501 for assistance.
PACKING LIST
Pressure Washer
25 ft. High Pressure Hose
Trigger Handle
Spray Wand
Quick-Connect Nozzles (4)
4-Cycle Engine Lubricant (SAE 30 or SAE 10W30)
Disposable Funnel
Handle
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate this
tool until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
All manuals and user guides at all-guides.com

ASSEMBLY

INSTALLING THE HANDLE
See Figure 2.
 Push and hold the button on the handle as you slide the
CONNECTING THE SPRAY WAND TO THE
TRIGGER HANDLE
See Figure 3.
 Place the threaded end of the spray wand in the connec-
 Turn the connector clockwise until it stops. This secures
CONNECTING HIGH PRESSURE HOSE TO
TRIGGER HANDLE
See Figure 4.
 Screw the collar on the high pressure hose into the
 Pull on the hose to be certain it is properly secured.
Page 7 — English
WARNING:
Do not attempt to modify this tool or create accesso-
ries not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
CAUTION:
Be careful to avoid pinching your fingers or hands when
installing the handle onto the frame.
handle into the holes in the frame.
NOTE: Before use, pull the handle up until the lock
button snaps through the locking slot to secure the
handle in place.
tor on the end of the trigger handle.
the spray wand in place.
trigger handle inlet coupler by turning the hose collar
clockwise. Tighten securely.
NOTE: Be careful to avoid cross-threading, which can
cause the trigger handle to leak during use.