Troubleshooting - Fulgor Milano FBC 345 TNF ED Manual De Usuario

7 - Troubleshooting

EN
If you have any problems with your appliance, you should
check the troubleshooting prior to calling Customer Care.
If the appliance is not working, check:
• That there is power to the appliance.
• The house fuses are intact and the fuse in the plug has not
blown.
• The fridge has not been turned off.
• The plug socket is functioning fine. To check this, plug
another electrical appliance in to see if the socket is
faulty.
If the appliance is working, but not very well,
check:
• The appliance is not overloaded.
• The thermostat is set to an appropriate temperature.
• The doors are closing properly.
• The cooling system at the rear of the appliance is clean and
free of dust, and not touching the rear wall.
• There is enough ventilation at the side and rear walls.
If the appliance is noisy, check:
• The appliance is level and stable.
• The side and rear walls are clear, and there is nothing
resting on the appliance.
• Note: The cooling gas in the refrigerator may make a slight
bubbling or gurgling noise, even when the compressor is
not running.
If the appliance is beeping, check:
• That the doors are closed. An alarm will sound after 60
seconds of a door being open.
If there's water in the base of the refrigerator
compartment, check:
• The drain hole at the back of the compartment is clear.
If ice has formed on the back wall of the fridge:
• It is normal for some ice droplets to form on the back wall of
the fridge. This does not constitute a fault with the appliance.
• Ensure that no items inside the fridge are in contact with the
back wall.
• Check that there is some resistance when opening the door
of the appliance. If it opens at the slightest touch it may
mean that the door seal needs to be replaced.
• Check the door seal for any kinks, debris or damage. If you
notice any, and are unable to resolve the issue yourself,
contact Customer Care so that the seal can be replaced.
• This can be due to the decor door(s) not being properly
fitted. If you are at all unsure, ask your fitter to check the
décor doors.
If excessive ice has formed in the freezer:
• Check that there is some resistance when opening the door
of the appliance. If it opens at the slightest touch it may
12
mean that the door seal needs to be replaced.
• Check the door seal for any kinks, debris or damage. If you
notice any, and are unable to resolve the issue yourself,
contact Customer Care so that the seal can be replaced.
• This can be due to the decor door(s) not being properly
fitted. If you are at all unsure, ask your fitter to check the
decor doors.
If one or more of the LED units within the appliance
is not working:
• Contact Customer Care to arrange a service visit.