Reversing The Appliance Door - Fulgor Milano FBC 345 TNF ED Manual De Usuario

Reversing the appliance door

We recommend you seek the help of another individual to
support the doors whilst performing this operation.
Remove the right upper hinge cover and hinge by
screwdriver.
Remove the upper door.
Remove the middle hinge and its connecting pin underneath.
Remove the bottom door.
1
2
3
4
Remove the right bottom hinge and left plastic plugs, and
refit them onto the opposite side.
Assembly the right upper hinge to the left bottom and fit
the cover.
Reassemble the doors and hinges workings from bottom to
top, from 1-4.
Ensuring the door seals correctly:
It is normal for the seal to be compressed after the door has
been reversed. With the door closed, use a hair dryer to
expand the seal and fill the gap between the door and the
body of the appliance. Take care not to use the hair dryer
too close to the appliance, which could damage the seal. A
distance of approximately 10cm should be adequate. When
completed, allow the seal and door to cool before touching
them. Once done, the seal should remain in position.
5
6
7
EN
17