Reversing The Appliance Door - Fulgor Milano FBR 300 F ED Manual De Usuario

Reversing the appliance door

We recommend you seek the help of another individual to
support the doors whilst performing this operation. Always
wear adequate PPE (Personal Protective Equipment) for the
task at hand.
Prepare a surface with a soft, clean towel or similar where you
can place the door during these steps.
Remove the right upper hinge cover and hinge by
screwdriver.
Remove the door.
Remove the right bottom hinge and left plastic plugs, and
refit them onto the opposite side.
1
2
3
Assembly the right upper hinge to the left bottom and fit
the cover.
Sit the door on the bottom hinge and assembly the bottom
hinge to the top, make sure 1-2-3 are very close.
Ensuring the door seals correctly:
It is normal for the seal to be compressed after the door has
been reversed. With the door closed, use a hair dryer to
expand the seal and fill the gap between the door and the
body of the appliance.
Take care not to use the hair dryer too close to the appliance,
which could damage the seal. A distance of approximately
10cm should be adequate.
When completed, allow the seal and door to cool before
touching them. Once done, the seal should remain in position.
4
5
EN
15