Charging The Rechargeable Battery; Scope Of Delivery - brennenstuhl MULTI 6050 MA Manual De Instrucciones

MULTI 6050 MA
Unlock the telescopic stand by sliding the two gray latches on the sides from the bottom
to the top and releasing them from the anchorage (Fig. 2b). Then unlock the light by
pressing the gray button by the battery indicator (Fig. 2c).
Now the stand can be set up vertically (Fig. 2d). Make sure that it audibly clicks into place
in the lock at the battery indicator. The telescopic stand can now be extended to the
desired height. To do this, start with the lowest step, open the yellow clamp lock, extend
the tripod to the desired height and lock it again with the yellow clamp lock (Fig. 2e).
This procedure can be performed up to four times until the illuminator has reached its
maximum height.
To move the light element to the desired position, the floodlight has two functions.
Set the floodlight in the desired direction by folding it up or down on the shaft side.
In addition, the floodlight can be rotated 180° (Fig. 2f ).
Important: always turn the floodlight back to its original position after use.
To switch on the floodlight, press the switch on the side. Pressing it several times switches
the light intensity from 100% to 75% to 50% to 25% and then to "off" (Fig. 3).
The less light output is set, the longer the light duration.
If a switch position is unchanged for more than 5 seconds, pressing it again always leads
to the "off" state.
If the battery is almost empty, the LED floodlight flashes five times. After that, the
floodlight will continue to shine at 50% brightness for about 10 minutes before the deep
discharge protection switches the floodlight off.
DISMANTLING
To properly repack the floodlight after use, first open the yellow clamp latches and retract
the stand to the minimum (Fig. 4a). Unlock the floodlight with the gray button on the
battery indicator (Fig. 4b). Now fold the telescope together with the light unit. The light
unit must audibly engage in the gray button at the battery display (Fig. 4c). Now lock the
lamp head with the gray anchors and fold the support legs together (Fig. 4d). Once the
floodlight is in its initial state (Fig. 4e), it can be safely stored in the transport bag.

CHARGING THE RECHARGEABLE BATTERY

Only use one of the manufacturer's original charging device: Bosch, Dewalt, Festool, Flex,
Makita, Metabo (CAS), Milwaukee.

SCOPE OF DELIVERY

Floodlight, 6 multi adapters Bosch, Festool, Flex, Makita, Metabo, Milwaukee/Dewalt,
adapter bag, bag for floodlight.
ACCESSORIES
Suitable accessories are available on our homepage www.brennenstuhl.com.
CLEANING
Remove the battery before cleaning.
Do not use solvents, caustic cleaning agents or similar products.
Only use a dry or slightly moistened cloth for cleaning.
012722 BA_MULTI 6050 MA 0533954.indd 11 012722 BA_MULTI 6050 MA 0533954.indd 11
Operating instructions
11 11
26.04.22 11:55 26.04.22 11:55