Stiga VILLA ROYAL Instrucciones De Uso página 50

All manuals and user guides at all-guides.com
GB
STARTING AND OPERATION
ENGINE CASING
To inspect and maintain the engine and battery, re-
move the engine casing. The engine must not be
running when the casing is removed.
Dismantling:
1. Fold up both casing locks at the rear edge
(fig. 4).
2. Pull the engine casing back a little first. Then lift
it off.
Assembly:
1. Fold the seat forward.
2. Align the casing's upper, front pins with the
slots in the front engine casing (fig. 5). Leave ap-
prox. 2 cm clearance.
3. Guide both conical side pins into the holes in the
front engine casing. Then press the entire casing
forwards.
5. Finally fold down both casing locks (fig. 4.)
The machine may not be operated un-
less the engine casing is mounted. Risk
of burns and crushing injuries.
FILLING THE FUEL TANK
Always use lead-free petrol. You must never use 2-
stroke petrol mixed with oil (fig. 6).
NOTE! Bear in mind that ordinary lead-free petrol
is a perishable; do not purchase more petrol than
can be used within thirty days.
Environmental petrol can be used, i.e. alkylate pet-
rol. This type of petrol has a composition that is
less harmful for people and nature.
Petrol is highly inflammable. Always
store fuel in containers that are made
especially for this purpose.
Only fill or top up with petrol outdoors,
and never smoke when filling or top-
ping up. Fill with fuel before starting
the engine. Never remove the filler cap
or fill with petrol while the engine is
running or still warm.
Never completely fill the petrol tank. Leave an
empty space (= at least the entire filler tube plus 1
- 2 cm at the top of the tank) to allow the petrol to
46
ENGLISH
expand when it warms up without overflowing.
CHECKING THE ENGINE OIL LEVEL
(Master – Senator – President)
On delivery, the crankcase is filled with SAE 30
oil.
Check the oil level every time before using to
ensure it is correct. The machine should be
standing on level ground.
Wipe clean around the oil dipstick. Un-
screw and pull it up. Wipe off the dipstick.
Slide it down completely and tighten it.
Then unscrew it and pull it up again. Read off the
oil level. Top up with oil to the "FULL" mark, if
the level comes below it (fig. 7).
CHECKING THE ENGINE OIL LEVEL
(Royal)
On delivery, the crankcase is filled with SAE
10W-40 oil.
Check the oil level every time before using to
ensure it is correct. The machine should be
standing on level ground.
Wipe clean around the oil dipstick. Un-
screw and pull it up. Wipe off the dipstick.
Slide it down completely without tighten-
ing it.
Pull it up again and read off the oil level. Top up
with oil to the "UPPER" mark, if the oil level is be-
low it (fig. 8).
SAFETY SYSTEM
This machine is equipped with a safety system that
consists of:
- a switch on the gear lever (only Master, Sena-
tor).
- a switch on the brake pedal (only President,
Royal).
- a switch in the seat bracket (all).
In order to start the machine, the following are nec-
essary:
- gear lever in neutral (applies to Master, Sena-
tor).
- brake pedal pressed down.
- driver sitting on seat.
Always check the operation of the safe-
ty system before using the machine!