Attaching The Adjusting Rail To The Door Panel; Attaching The Fixation Strips To The Door Panel - Thermador T18 Serie Instrucciones De Instalación

7. Attaching the adjusting rail to
the door panel
1. Measure the distance
and the overhead cabinet/fixtures.
2. Loosen the 2 nuts (a) and remove the adjusting
rail (b).
3. Mark this amount A on the rear of the door panel.
4. Determine and mark the centerline of the door pan
5. Put on the adjusting rail and align along the marks.
Mark the drill holes.
6. Drill the holes.
7. Screw on the adjusting rail tightly.
20
All manuals and user guides at all-guides.com
A between the adjusting rail
Notes:

Attach the adjusting rail to the door panel with at
least 10 screws. One screw should be inserted
under each double threaded bolt.

The adjusting rail features a variety of holes for
many different design options of door panels.
Always screw into the best
the door panel.
8. Attaching the fixation strips to the
door panel
Note:
The fixation strips are pre-assembled for stainless
doors. In this case continue wi th the next installation step
("C / 9. Attaching the door panel").
1. Hang the door panel on the double threaded
bolt (a).
2. Align the door panel with the double threaded bol
(Torx screwdriver).
Re-examine the dimensions
Use the height adjustment gauge (b).
el.
3. Transfer the middle drill holes along the outer e
of the appliance door to the door panel and mark.
4. Remove the door panel.
the
load-bearing material of
steel
ts
of the gap continuously.
dge