Practical Advice - Bosch UniversalDistance 50 Manual Original

All manuals and user guides at all-guides.com
26 | English
Press the measuring button (4) to start another area measurement.
Measure the area as described in the section on area measurement (see
14.049 m
2
"Area measurement", page 24). To complete the addition, press the
+84.295 m
2
measuring button (4). To add more measured values, press the button
98.345 m
2
(7) [+] again and repeat.
Subtracting values
To subtract values, press the button (2) [–]. The subsequent steps are the same as for
the section on adding values.
List of the last measured values/calculations
The measuring tool stores the last ten measured values and their calculations and dis-
plays them in reverse order (most recent measured value/most recent calculation dis-
played first).
Press the (6) button to display the list of measured values.
Deleting measured values in the measured value list
Briefly press the on/off button (8) to delete the currently displayed measured value.
Press the (6) button and the on/off button (8) simultaneously to delete all measured val-
ues from the list.

Practical Advice

General advice
The reception lens (12) and the laser beam output (13) must not be covered during the
measuring process.
The measuring tool must not be moved while a measurement is being taken (unless in
continuous measurement mode). It is therefore advisable to place the measuring tool at
or on the measuring points.
The measurements are taken at the centre of the laser beam, even when the laser is poin-
ted at surfaces diagonally.
Influences on the measuring range
The measuring range depends on the lighting conditions and the reflective properties of
the target surface. For better visibility of the laser beam when working outdoors and in
bright sunlight, use the laser viewing glasses (15) (accessory) and the laser target plate
(16) (accessory) or shade the target area.
1 609 92A 4PE | (25.10.2018) Bosch Power Tools