Operation; Switching On And Off; Fitting The Sanding Sheet; Extracting Dust - Parkside PPS 200 C2 Traducción Del Manual De Instrucciones Original

Operation

Switching on and off
Switching on
♦ Press the ON/OFF switch 0 to position "I".
Switching off
♦ Press the ON/OFF switch 0 to position "0".

Fitting the sanding sheet

WARNING!
► Always remove the plug from the mains
power socket before carrying out any work
on the appliance.
NOTE
Before fitting a new sanding sheet 7, remove
►
any dust and dirt from the sanding plate 6,
8 and 9.
► Ensure that the extraction holes on the sanding
sheet match up with those on the sander plate.
Position the sanding sheet 7 flush on one side
♦
of the sanding pad 6, 8 and 9.
Then place the sanding sheet 7 on the sanding
♦
pad 6, 8 and 9 and press it firmly into
place.
Different materials require different grain sizes.
You can find out which grain is suitable for which
work in our non-binding recommendations in
"Work instructions, tips and tricks".
■ 6 │ GB │ IE

Extracting dust

Wear a dust mask!
WARNING! RISK OF FIRE!
► When working with power tools that are fitted
with a dust collector 3 or can be connected
to a vacuum cleaner via the vacuum cleaner
adapter, there is a risk of fire! In unfavourable
conditions, e.g. when sparks are flying while
sanding metal or metal residues in wood,
wood dust in the dust sack (or in the vacuum
cleaner dust bag) can spontaneously ignite.
This is a particular risk if the wood dust is
mixed with paint residues or other chemicals
and the workpiece has become hot after
being worked for a long time. Therefore, do
not allow the workpiece to overheat and
always empty the dust collector 3 or the
dust bag in the vacuum cleaner before taking
a break from work.
Dust extraction with dust collector
Attaching the dust collector
Push the dust collector 3 onto the appliance.
♦
Make sure that the
collector 3 is aligned with the ▸ symbol on the
appliance. Turn the dust collector 3 to the
symbol to lock it in place (see detailed illustra-
tion on upper part of the fold-out page).
Removing the dust collector
♦ Turn the symbol on the dust collector 3 to
the ▸ symbol on the appliance (see detailed
illustration on upper part of the fold-out page).
Pull the dust collector 3 off the appliance.
NOTE
► To ensure optimum extraction, regularly empty
and shake out the dust collector 3. To do so,
press the release button 2 to pull the rear
part of the dust collector 3 off the appliance.
Now remove the dust bag
bag thoroughly by tapping it out.
3a
► Perforated sanding sheets are required for
dust extraction.
symbol on the dust
. Clean the dust
3a
PPS 200 C2