Hazards Caused By Flying Parts; Hazards Caused By Entanglement; Hazards During Operation; Risks Due To Repetitive Movements - Parkside PDEXS 150 C2 Instrucciones De Uso

Hazards caused by flying parts
■ If a workpiece or accessory or even part of the
machine tool itself breaks, parts can be flung
out at high speeds.
■ When operating the sanding machine for sanding
sheets or the polisher or when exchanging acces-
sories on the device, always wear eye protection.
The degree of necessary protection must be evalu-
ated separately for each individual task.
■ Wear a safety helmet if working above head
height.
■ In this case, the risks for other persons should
also be assessed.
■ You must ensure that the workpiece has been
securely fixed.

Hazards caused by entanglement

■ Suffocation, scalping or and/or cut wounds can
occur if loose clothing, jewellery, necklaces, hair
or gloves are not kept away from the machine
and its accessories.

Hazards during operation

■ When using the machine, the operator's hands
can be subject to hazards such as cuts, grazing
and heat. Wear suitable gloves to protect your
hands.
■ The operator and maintenance personnel must
be physically capable of handling the size,
mass and power of the machine.
■ Hold the machine correctly: be ready to coun-
teract any normal or sudden movements - have
both hands ready.
■ Ensure that your body is balanced and that you
have a secure standing position.
■ Release the start/stop control in case of a dis-
ruption of the energy supply.
■ Use only lubricants recommended by the manu-
facturer.
■ Protective goggles must be worn. It is recom-
mended to wear protective gloves and protec-
tive clothing.
■ Check the sanding disc before every use. Do
not use if this is cracked, broken or has been
dropped.
│
■ 4 US - EN
All manuals and user guides at all-guides.com
■
■
■
■

Risks due to repetitive movements

■
■
■

Hazards caused by accessories

■
■
Avoid direct contact with the movable sanding
disc to avoid squashing or cutting your hands or
other parts of the body. Always wear suitable
gloves to protect your hands.
Never use the machine without an abrasive
attachment.
There is a risk of electrostatic discharge if the
machine is used on plastic and other non-
conductive materials.
Dust and vapours created by the sanding and
sanding can cause a potentially explosive at-
mosphere. Always use a dust extraction or sup-
pression system suitable for the material being
worked.
When using a sanding machine for sanding
sheets or a polisher to perform work-related
activities, operators may experience uncomfort-
able sensations in their hands and arms, as well
as in the neck and shoulders or other parts of
the body.
When using a sanding machine for sanding
sheets or a polisher, the operator should adopt
a comfortable posture whilst ensuring a secure
hold and avoiding awkward postures or posi-
tions in which it is difficult to maintain balance.
The operator should change positions during
the course of long-lasting tasks. This can be
helpful in the prevention of discomfort and
fatigue.
If the operator notices symptoms such as persis-
tent or recurring illness, discomfort, throbbing,
pain, tingling, burning or stiffness, these indica-
tions should not be ignored.
In this case, the operator should consult a suitably
qualified physician.
Disconnect the sanding machine for sanding
sheets or the polisher from the power supply
before fitting or replacing the machine tools or
accessories.
Avoid direct contact with the machine tool during
and after use, since this can have heated up or
have become sharp.
PDEXS 150 C2