CONTROL PANEL FEATURES
1. Output Ready Indicator LED (Green): Illuminates
when the generator is operating normally and
indicates the generator is producing electrical
power at the receptacles.
2. Overload Indicator LED (Red): Illuminates when
the generator is overloaded which means the
generator's wattage / amperage capacity has been
exceeded by connected electrical devices or by a
power surge.When this occurs, the Output Ready
Indicator LED will go off. The engine will continue
to run, but the red Overload Indicator LED will stay
on, and power will no longer be supplied to
connected electrical devices.To rest the generator:
Remove all applied loads and stop the engine.
Review for any faulty or shorted connections.
Start the generator and reconnect electrical devices
sequentially, allowing the generator to stabilize after
each device is connected. Make sure the total
wattage of connected electric devices are not
exceeding recommended rated output power.
1
2
3. Oil Warning Indicator LED (Red): Illuminates
when the engine oil level falls below the safe
operating level and the generator will automatically
shut off the engine. The engine will not start until
the proper amount of oil is in the crankcase.
Page 10
3