Before Starting The Generator; Starting The Engine (Generator); Select The Fuel Source (Gasoline) - iPower SUA2000iD Manual Del Propietário

Before Starting the Generator

• Make certain the generator is on a flat, level surface
and well-ventilated location. Check for loose or
missing parts and for any damage which may have
occurred during shipment.
• Check oil level and fuel.
• Disconnect all electrical loads from the generator.
Never start or stop the generator with electrical
devices plugged in or turned on.

Starting the Engine (Generator)

Select the Fuel Source (Gasoline)

1. Make certain the propane tank is fully closed.
2. Turn the fuel cap vent lever to the "ON" position.
ON
3. Turn the fuel source switch to the gasoline
position.
4. Pull the choke knob out to the "START" position.
5. Turn the engine switch to the "ON"(l)
6. Pull recoil starter slowly until resistance is felt,
then pull rapidly.
7. As soon as engine starts and warm up, push the
choke knob in to the "RUN" position.
Page 16
position.