To delete a program
1 :
Delete a program (P1,P2 or P3)
Press the dial (short press). Rotate dial
until the program icons are flashing
together (second screen).
2 : Select the program to delete
Press the dial (short press). Rotate dial
until the program you want to delete
is flashing.
3 :
Hold the button to delete it
When the P icon is flashing hold down
the Water Now button for 3 seconds and
release. The data has now been deleted.
PROGRAM DATA IS DELETED
You can make changes to other settings
or press the Water Now button to quit
making changes.
Factory Reset
1 : Perform a full reset of the timer
Press the dial and
+
Water Now button
down
for 8 seconds and
release.
2 : Confirm full reset
Press the dial to confirm
YES or rotate the dial to NO
and press the dial to quit.
3 : All data is deleted
After a full reset all data has been
deleted. You must now set up your timer
again to start using it. Refer to "Set up -
first use" section.
Battery Status
A set of Alkaline or Lithium type batteries should
last for one season in normal conditions.(based
upon watering twice a day for 6 months). Always
use new batteries at the start of a watering season.
The battery status is displayed in the top right
together
corner of the screen.
New Batteries.
New Batteries.
Battery level OK.
Battery level OK.
Replace batteries soon.
Replace batteries soon.
When a new set of batteries is installed you will
need to set the clock and the current day of the
week again. However your program data (P1, P2
and P3) will be retained in memory.
FAILURE PREVENTION MODE
A built in safety feature detects when the battery
levels have dropped to a level that could fail whilst
the valve is open and result in wasting water. The
safety mode prevents the controller from turning
on until the batteries have been replaced. The
screen will display the word "BATT" when the failure
prevention mode has been activated. The water
now function
will also not
operate until
the batteries
are replaced.
Battery
status
7