Publicidad
Step 12
Step
Flip the drawer over onto the LEFT DRAWER SIDE (D88).
å
Insert a SLIDE CAM (BB) into the DRAWER RIGHT SIDE (D87).
å
Diagram 1. Insert the tabs on a DRAWER STOP (20G) into the slots in a EXTENSION SLIDE (N). You may need to insert
å
one tab fi rst, then the other.
Diagram 2. Visually check that the DRAWER STOP (20G) is seated in the EXTENSION SLIDE (N).
å
Diagram 3. If the DRAWER STOP is not seated, use your hammer to gently tap the SLIDE until the tabs are properly seated
å
in the slots.
Now, fasten the EXTENSION SLIDE (N) to the DRAWER RIGHT SIDE (D87). Use two GOLD 5/16" FLAT HEAD SCREWS (GG)
å
through holes #1 and #4.
Repeat steps 12 and 13 for the remaining drawer.
å
1.
N
20G
These tabs must
insert into the slots.
Post
2.
N
Page 16
Slot
D87
20G
Seated
Open end
1
2
N
3
4
D88
3.
401444
Screw head - turn CAM to
line up holes in the SLIDES
with holes in DRAWER SIDES
BB
GG
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
www.sauder.com/services
Publicidad
