Publicidad
Step 4
Separate the EXTENSION SLIDES (N) from the
å
EXTENSION RAILS (M) as shown in the upper diagram.
Be prepared, the parts are greasy.
Fasten four EXTENSION RAILS (M) to the ENDS (A2
å
and B). Use eight GOLD 5/16" FLAT HEAD SCREWS (GG).
NOTE: For each EXTENSION RAIL, turn a SCREW into
å
the hole shown in the enlarged diagram. Then, slide the
innercartridge of the EXTENSION RAIL in to fi nd the other
hole that lines up with the hole in the END. Turn a SCREW
into this hole.
Push the black lever in and pull the SLIDE from the RAIL.
Open end
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
Page 8
N
M
B
M
GG
M
M
A2
After fastening the EXTENSION RAILS to the
RIGHT END (A2), the SAFETY STOPS should touch
the top edge of the RAILS. If the gap is larger than
1/16", the drawers could lock up and not open. If
this happens, open two drawers at the same time to
override the interlock system. Remove the drawers
to re-adjust the INTERLOCK TRACK assembly.
401444
Remember:
Righty tighty.
Lefty loosey.
Open end
M
www.sauder.com/services
Publicidad
