Tabla de contenido
Publicidad
Language selection
key
•
Press [_
key.
•
Select the language you need.
•
Press the [_
key to memorize the language
selected.
The screen will automatically be returned to the
main menu.
(!) Language selection key
Notel
Regardless of which language is selected on the
machine,
any message stored in the Memory
Card
is shown on the visual touch screen in English only.
Changing
Needles
Raise the needle by pressing the up/down
needle
button
and lower the presser foot.
Turn off the power switch.
Loosen the needle clamp screw by turning
it
counterclockwise.
Remove the needle from the clamp.
Insert the new needle into the needle clamp with
the flat side to the rear.
When inserting the needle into the clamp, push it
up as far as it will go. Tighten the clamp screw
firmly by turning it clockwise.
To check for a good needle, put the flat side of the
needle onto something flat (the needle plate, glass,
etc.).
The gap between the needle and the flat surface
should be consistent. Never use a bent or blunt
needle.
(_) Needle clamp screw
(_
Pin
(_) Needle clamp
I ll© Ii ©
[
!
d
To Attach and Remove Presser Feet
Press the red button on the back of the foot holder.
The presser foot will drop off.
Place the selected presser foot so the pin on the foot lies
just under the groove of the foot holder. Lower the
presser bar to lock the foot in place.
(_) Red button
(_Groove
(_)Pin
-.,.a
%
I0
Publicidad
Tabla de contenido
