Buttonhole Lever - Sears Kenmore 385.19000 Manual De Instrucciones

Sensor Buttonholes, cont'd
• Pull the button holder to the back, and place the
button in it. Push it together tighdy on the
burton.
@ Burton holdel
• Pull the buttonhole lever downward as far as it
will go.
@
Buttonhole
lever
Draw both threads to the left under the foot.
Insert the garment under the foot, and lower the
needle at the start point.
Then lower the automatic buttonhole foot.
Make sure there is no gap @ between the slider
(f!) and the spring holder @.
If there is a gap @, the length of the rows will
be different, as shown in @.
(_) Mark for placement of buttonhole
(_) Starting point
(_) Slider (_) Spring holder
_) There shoud be no gap. (_) Difference
The buttonhole will be sewn automatically; the
front barrack and left row first, then the right
row and back bartack. The machine wilI stop
automatically when the buttonhole is
completed.
Depress the foot control until the machine stops
automatically.
Remove the fabric and place a pin just before the
bartack at each end to prevent cutting bartacks.
Cut the opening with the buttonhole opener.
When finished, pushthe buttonholeleverupas Mr
it will go.
@s_p]
(_)S_p2
(_S_p3
@ @ @
46