Corded Buttonhole - Sears Kenmore 385.19000 Manual De Instrucciones

Corded Buttonhole
Use the same procedure as #12 square buttonhole.
(see page 44)
Set the stitch width to match the thickness of the
cord used.
With the buuonhoie foot raised, hook the filler
cord on the spur at the hack of die buttonhole foot.
Bring the ends toward you tinder the buttonhole
foot, clearing die front end.
Hook the filler cord into the forks on the front of
automatic buttonhole foot R to hold them tight.
Lower the needle into the garment where the
buttonhole will start and lower the foot.
Depress the foot control gently and sew the
buttonhole. Each side of the buttonhole and rhe
bartacks will be sewn over tile cord.
Remove the fabric from the machine and cut the
sewing threads only.
(_ Tension
(_) R: BH foot
(_) Spur
([_) Needle thread
(_) Bobbin thread
.%
Pull the left end of the filler cord to tighten it.
Thread the end through a darning needle.
Draw to the wrong side of the fabric and cur.
* To cut the buttonhole opening, refer to the
instructions on page 46.
5O