Bombard TYPHOON 200 ROLL UP Manual Del Propietário página 25

MODELS ROLL-UP (WITH SLATS) : INSTALL THE SLATTED FLOOR:
If the slats are not already installed, boat deflated, slide the slats in their pockets starting by the
closest to the transom. If the slats are difficult to insert, lubricate it with liquid soap.
MODELS AERO: INSTALL THE INFLATABLE AEROTEC FLOOR
AEROTEC INFLATABLE FLOOR DEFLATED
MAINTENANCE / DISMANTLE OF THE AEROTEC INFLATABLE FLOOR
We recommend that you leave the
However, to clean perfectly the boat it may be useful to take off the
1. DISMANTLE: Deflate the boat
Aerotec
Take off the floor (reverse the installation procedure).
2. MAINTENANCE: inflate again the boat
Wash off with clear water, and then raise the boat's nose to evacuate water and sand or
rubbish.
ASSEMBLY
Choose a smooth and clean surface
IF THE BUOYANCY TUBE WAS STORED AT A TEMPERATURE BELOW 0°C
/ 32°F, LEAVE IT AT 20°C / 68°F FOR 12 HOURS BEFORE UNFOLDING.
Aerotec
floor in the boat when folding.
Aerotec
3 / 11
floor:
E
N
G
L
I
S
H