Bombard TYPHOON 200 ROLL UP Manual Del Propietário página 30

INFLATING AN AERO BOAT (WITH AN INFLATABLE FLOOR)
Activate all valves in the inflation position.
Attach the hose connector to the inflator inflation port.
To inflate your boat properly, the inflator should be
correctly placed on the ground.
The boat inflates rapidly if the inflator is used smoothly
and without haste.
CAUTION
A - INFLATE THE HIGH PRESSURE FLOORBOARD
1. Inflate Insert the pipe as shown in figure A (with the cap inserted) and begin to inflate
leaving the cap inserted. The inflator uses its full capacity. Inflate until hard.
2.
Then remove the cap. The pump automatically uses the smallest chamber needed to provide
the High Pressure bottom inflation pressure without undue force. Complete inflation in position B
until the recommended pressure is reached
B - INFLATE THE MAIN BUOYANCY TUBE AND THEN THE KEEL
CAUTION
Inflate the buoyancy tube Insert the pipe
and begin to inflate leaving the cap inserted. The inflator uses its full capacity and allows the
recommended pressure
pressures between the compartments are equalized, until the partitions (a) can no longer be
seen.
Never pressurise a
compartment when the
others are completely
Then inflate the keel
Inflating is complete: screw on the inflating valve caps.
DO NOT USE A COMPRESSOR OR COMPRESSED AIR CYLINDER.
NEVER USE POSITION B TO INFLATE THE BUOYANCY
TUBE OR THE KEEL: BURSTING HAZARD.
as shown in figure A (with the cap inserted)
(see "PRESSURE" section)
deflated
1
2
(see "PRESSURE" section). Note : no keel on 235 Aero model.
(AERO MODELS ONLY)
(see "PRESSURE" section)
) to be achieved. Make sure that the
8 / 11
a