Bombard TYPHOON 200 ROLL UP Manual Del Propietário página 29

INFLATING A NON AEROTEC BOAT (WITH BATTENS OR RIGID FLOOR)
Activate all valves in the inflation position.
Attach the hose connector to the inflator
inflation port.
To inflate your boat properly, the inflator
should be correctly placed on the ground.
The boat inflates rapidly if the inflator is used
smoothly and without haste.
CAUTION
You can us the electrical air pump
INFLATING THE BUOYANCY CHAMBER
• Inflate the buoyancy mechanism, balancing the pressure between the different
compartments until the partitions (a) are no longer visible
Never pressurise a
compartment when the
others are completely
deflated
INFLATING THE KEEL
• Once the floorboard is installed, start inflation (see "PRESSURE" section)
Inflating is complete: screw on the inflating valve caps.
NOTE:
DO NOT USE A COMPRESSOR OR COMPRESSED AIR CYLINDER.
ACCESS
(ask your Dealer).
1
2
(see "PRESSURE" section)
A slight air leak is normal before the valve cap is screwed on
ONLY THE VALVE CAPS CAN ENSURE FINAL AIR TIGHTNESS.
(see "PRESSURE" section)
(see "PRESSURE" section)
a
7 / 11
E
N
G
L
I
S
H