DeWalt D24000 Manual De Instrucciones página 37

c. Slide the cutting cart assembly onto the rail system.
Tilt the front of the cart upward slightly to clear the
cart stop.
STEP 4
4. The outer rim of the cutting wheel should always be
at least 3/16" (5 mm) below the cart surface. Push cart
entirely through the cutting wheel before cutting to be
sure that the cutting wheel depth is properly adjusted to
avoid cutting the cart. Adjust the depth of cut knob
and tighten the locking wing nut
knob 4 .
For further details, refer to Adjustments in the
Instruction Manual.
All manuals and user guides at all-guides.com
STEP 5, 6, 7, 8
5. Place the saw in the water pan. The water pan drain hole
6. Attach the water pump to the water line and insert pump
7. Fill the pan with 5 gallons (19L) of water. The pump
8. Turn saw on. If lower water flow is desired, use the flow
28
39 , then the head lock
28
39
should be in the front position.
power cord into the socket. Position pump properly in
pan, as shown.
should be submerged.
NoTE: For longer pump life, always place the pump in a
clean water source.
restrictor on the water line.
ENGlIsH
3/16" (5 mm)
4
35