Intended Use - DeWalt D24000 Manual De Instrucciones

ENGlIsH
COMPONENTS (FIG. A)

WARNING: Never modify the power tool or any part
of it. Damage or personal injury could result.
Refer to Figure A at the beginning of this manual for a
complete list of components.
The motor arm assembly comes assembled. Open the box
and lift the assembly out, as shown in Figure B.
Fig. B

INTENDED USE

This tile saw is designed for professional tile
cutting applications.
Do NoT use under wet conditions or in presence of
flammable liquids or gases.
This tile saw is a professional power tool. Do NoT let
children come into contact with the tool. Supervision is
required when inexperienced operators use this tool.
ASSEMBLY (FIG. A, C, D)

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
1. Place saw frame assembly 12
2. Using the supplied wrench remove the screws
the saw frame assembly.
3. Place motor arm 2 on frame assembly.
4. Secure the saw head by installing two of the screws
into the holes closest to the rail. Tighten the screws with
the wrench provided. Install the other two screws in the
other two holes and tighten.
5. Place the saw assembly into the water pan
shown in Figure A.
6. Tilt the front of the cutting cart assembly
slight angle. Align the arrow on the rear of the cutting
cart with the round rail on the frame of the saw. Slide
the cutting cart assembly onto the rail system clearing
the cart stop with both pairs of rollers.
7. Place the threaded fitting onto the water pump
Attach the clear water tube 16
(Fig. D). Place the water pump in the deep corner of the
water pan, near the drain plug. Insert the pump power
cord into the socket 17 .
8. Install rear water attachment
9. Install cutting cart water attachment
36
All manuals and user guides at all-guides.com
Fig. D
To Attach Cutting Wheel (Fig. C, E)
1. Using the smaller hex wrench supplied, loosen (do not
2. Press spindle lock button
on a stable surface.
3. Install the cutting wheel
15 from
15
4. Replace cover and tighten screw
5. Adjust cutting wheel depth (see Cutting Wheel Depth).
Fig. E
11 as
down on a
8
.
40
to the threaded fitting
7 .
9 .
Fig. C
17
1
15
16 12
16
remove) the screw 18 on the side of the cutting wheel
cover 5 . Pull the rubber side flap back and lift the cover
toward the rear of the saw.
21 . Remove the cutting
wheel nut 19 with hex wrench provided. Remove
outer flange 20 .
6 with the rotational arrow
facing the same way as on the rotational arrow on the
cutting wheel cover. Press the spindle lock button while
tightening the cutting wheel nut.
18
21
13
40
18 .
5
6
19
20