DeWalt D24000 Manual De Instrucciones página 42

ENGlIsH
Adjustments (Fig. N–Q)

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Cutting Cart Scale
1. Unplug the saw.
2. Move the cart so the cutting wheel is near the cart
fence. 24 .
3. Using a tape measure or scale, check the scale on
the cart.
4. If the scale is in error, loosen the two screws
that hold the scale 32 in place, adjust to the correct
dimension and tighten the screws.
Cutting Wheel Square to Cart
1. Place a 90º square on the cutting cart.
2. If the gap is not consistent, loosen the bevel lock
knob 29 and adjust the 0º bevel adjustment screw
with supplied wrench until the cutting wheel is 90º to
the cart surface.
3. Ensure that the cutting wheel does not touch either side
of the groove in the cutting cart by pushing the cart
past the cutting wheel with saw turned off.
Cutting Wheel 45º to the Cart
1. Loosen bevel locking knob and rotate the cutting head
to 45º.
2. Put a 45º guide on the cutting cart surface next to the
cutting wheel. If it is not at 45º, adjust the 45º bevel
adjustment screw with the supplied wrench until
42
the cutting wheel is 45º to the cart surface.
3. With saw turned off, ensure that the cutting wheel does
not touch either side of the groove in the cutting cart by
pushing the cart past the cutting wheel.
Cutting Parallel to Cutting Cart
1. Lay a 90º square flat on the cutting cart surface with one
end against the cart fence 24
2. If the cutting wheel is not 90º to the cart fence, the rail
will need adjustment.
3. Loosen the four rail assembly mounting screws
4. Position the rail adjuster until the cutting wheel is
35
square to the cart fence.
5. Tighten the four rail screws.
Cart Rolling Resistance
(Rail Adjustment)
1. Loosen the four rail height screws
2. Adjust the two rail height adjusters
moves smoothly.
3. Tighten the four screws.
Bevel Pointer (Fig. N)
Loosen the 0º bevel pointer screw
pointer 30 to the correct location.
40
All manuals and user guides at all-guides.com
Depth of Cut
1. Loosen head lock knob
2. Adjust depth of cut knob
3. With the unit turned off, push the cart past the cutting
4. Adjust the depth of cut knob and tighten the locking
Cut Indicator
The cut indicator
cuts by showing where the blade will exit the cut. The cut
indicator can be used multiple times before adjustment
31
is necessary.
1. Loosen locking screw
2. Rotate cut indicator to expose uncut surface.
3. Tighten locking screw.
Fig. P
33
39
42
Fig. Q
36
.
.
34
MAINTENANCE

37 .
36 until cart
Brushes (Fig. R)
38 and rotate the bevel
Inspect carbon brushes regularly by unplugging tool,
removing the brush cap
4 .
28 until the cutting wheel is
at least 3/16" (5 mm) below the cart surface.
wheel and ensure that the cutting wheel does not
touch the cart.
wing nut 39 , then the head lock knob
27 assists in aligning long and diagonal
43 .
28
33
37 35
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
41 and with drawing the brush
4 .
3
29
34
36