KALLISTA P21688-00-BL Instrucciones De Instalación página 4

2. Connect the Drain Body
Finished
Wall
NOTE: The supplied pipe is 14-13/16" (376 mm) in length.
Measure the length from the drain stub-out to the inner-most edge of the outlet
nut.
If the measured length is less than 14-13/16" (376 mm), cut the pipe using a
hacksaw. Use care not to damage the finish.
With the threads of the outlet nut facing toward the bottle trap body, slide the
outlet nut with O-ring onto the pipe.
NOTICE: For proper compression fit, the pipe must be inserted at least 1" (25 mm)
inside the bottle trap body.
Insert the pipe at least 1" (25 mm) inside the bottle trap body.
Handtighten the outlet nut until flush against the bottle trap body. If necessary,
use a clean strap wrench to assist.
Slide the flange onto the free end of the pipe.
1491202-2-A
Drain Stub-Out
Flange
Measure.
4
Pipe
Outlet
Nut
To Sink
Kallista