Storage Of Headset; Certification And Safety Approvals - Samsung WEP150 Manual Del Usuario

13

Storage of headset

1. Always store the Samsung WEP150 with power off and safely protected.
2. Avoid storage at high temperatures (above 60°C / 134°F) – such as in a hot vehicle
or in direct sunlight. (Storage at high temperatures can degrade performance and
reduce battery life).
3. Do not expose the headset or any of its supplied parts to rain or other liquids.
14

Certification and safety approvals

This product is CE marked according to the provisions of the R & TTE Directive
(99/5/EC).
Hereby, Samsung, declares that this product is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC.
For further information please consult http://www.samsung.com
Please note that this product uses radio frequency bands not harmonised within
EU. Within the EU this product is intended to be used in Austria, Belgium, Cyprus,
Czech Republic, Denmark, Estonia, Hungary, Finland, France, Germany, Greece,
Ireland, Italy, Latvia, Lithuania, Luxembourg, The Netherlands, Malta, Poland,
Portugal, Slovakia, Slovenia, Spain, Sweden, United Kingdom and within EFTA in
Iceland, Norway and Switzerland.
Users are not permitted to make changes or modify the device in any way.
Changes or modifications not expressly approved by Samsung will void the user's
authority to operate the equipment.
10
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Users are not permitted to make changes or modify the device in any way. Changes
or modifications not expressly approved by Samsung will void the user's authority to
operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
The user must place the base 8" (20cm) or more from any personnel in order to
comply with FCC RF exposure requirements.
The device and its antenna must not be co-located or operating in conjunction with
any other antenna or transmitter.
11