Storage
Refrigerator Storage
FLIP-UP DAIRY COMPARTMENT
The bottom of the dairy compartment rotates upward
to accommodate taller items below. For models without
vertical dividers in the compartment, the entire bottom
rotates upward. For models with a vertical divider, one
section rotates upward. Refer to the illustration below.
Flip-up dairy compartment
8 | English
GLASS SHELVES
To reposition a glass shelf:
To remove, tilt the shelf up, then lift up and out. Refer
1
to the illustration below.
2
To install, insert the shelf in the tracks along the back
wall, then lower the front until it locks into position.
IMPORTANT NOTE: Use care when handling glass shelves
to prevent breakage or scratching the interior.
CAUTION
Glass shelves should warm to room temperature
before immersing in warm water.
Glass shelf removal
REFRIGERATOR DRAWERS
To remove and install a refrigerator drawer:
To remove, pull the drawer open until it stops.
1
2
Lift the front of the drawer slightly and pull straight out.
Refer to the illustration below.
3
To install, pull the drawer carrier out and align the
bottom of the drawer with the carrier.
Slide the drawer back into position.
4
To reposition a refrigerator drawer divider:
1
To remove, pull the divider straight up.
To install, align tabs on the divider with notches in the
2
drawer and push down.
Refrigerator drawer removal
Freezer Storage
WIRE SHELVES
To reposition a wire shelf:
To remove, tilt the shelf up, then lift up and out.
1
2
To install, insert the shelf in the tracks along the back
wall, then lower the front until it locks into position.
FOLD-UP FREEZER SHELF
For models with an ice dispenser, the fold-up shelf rotates
up and down to accommodate large or small items.
Fold-up freezer shelf