3. Before charging, check the electrolyte level in each battery unit.
For safety: Please wear protective gloves and eye protectors when treating the battery and
battery wiring when repairing the machine. Avoid contacting the battery liquid acid.
4. Plug the AC (alternating current) power cord of the charger to the power socket with sound
grounding.
5. The charger will automatically start charging and will automatically switch off when it is full.
Note: The machine will not work when being connected to the charger.
Note: during the charging of the charger, please do not pull the DC cord of the charger out of the
socket of the machine to avoid generation of arc strike. If the charging must be suspended
during the charging, please pull out the AC power cord firstly.
Warning: fire or explosion hazard. Please be away from spark or open fire. The battery
cabin must be kept open when charging.
6. After the charging is completed, recheck the electrolyte level.
When transporting the machine with truck or trailer, please ensure to following the following
binding procedure:
1. Lift up the brush head to the transport position
2. Use the suggested handling apron to load and unload the machine.
3. Lean the front of the machine closely against the front part of the truck or trailer. When the
machine is placed properly, lower down the brush head and tum the key to the close position.
4. Place blocks behind each driving wheel to prevent the machine from sliding.
5. Use the rope to fix the top of the machine to prevent titling. You must install bracket on the
sweeping board of the truck or trailer. For safety: when transporting the machine, please use the
suggested handling apron.
1. Please charge the battery before storage. Do not store the battery with the power running out.
2. Drain and flush thoroughly the bottom of the water tank.
3. Store the machine in a dry place.
If the machine is stored in a cold environment, please indeed drain all liquid n the machine
EN
11 MACHINE TRANSPORT
12 MACHINE STORAGE
23