Before starting to work with the machine, please follow the instructions below:
1. Before use, check the general condition and safety status of the device with work tools, specifically the condition of the power
cord and the extension cord. If not in perfect condition, use of the machine is prohibited.
2. Connect the battery (Fig.1)
3. Unblock the handlebar by pushing up the hinge pin with the foot or the hand (Fig.2).
4. Turn the machine on by pressing the switch (1) into the ON position (Fig.3).
ATTENTION: During these procedures, do not put foot on top of the device.
1
At the end of work and before carrying out any maintenance on the machine, follow the instructions below:
1. Turn off the machine (Fig.1)
2. Disconnect the battery (Fig.2).
ATTENTION: These operations must be carried out while wearing protective gloves to protect against possible contact with
edges or tips of metal objects.
ATTENTION To avoid damage to the power cord, disconnect the plug from the electrical outlet by pulling directly on the plug
and not on the power cord.
Proceed with scrapping the machine at a demolition centre or an authorized scrap collection centre.
Before scrapping the machine, the following components must be removed and separated and sent to separate
waste recycling centres following the norms governing environmental hygiene:
• Cleaning or abrasive pads
• Electrical and electronic parts (especially for scrapping – specifically for these, please contact the manufacturer
or your distributor)
• Batteries
• Plastic parts
• Metal parts
• Carton / packaging parts
Attention!
• This product must not be disposed with normal household waste.
• Separate disposal of used products and packaging allows the recycling of the materials and therefore their
continuous reuse! This contributes to environmental protection and prevents pollution and consumption of materials
Attention: Separate disposal. This product must not be disposed with normal household waste.
Attention: Discharge the batteries completely before disposal.
Attention: Separate disposal of used products and packaging allows the recycling of the materials and therefore
their continuous reuse! This contributes to environmental protection and prevents pollution and consumption
of primary materials.
WORKING WITH THE MACHINE
1
2
AT THE END OF WORK
1
1
DISPOSAL / SCRAPPING
3
2
27
1