Prepare A Drip Loop; Unpack The Machine; Install The Upper Panel; Install The Spray Gun Holder - GreenWorks Pro GPW2500C Manual Del Operador

3.1.1

PREPARE A DRIP LOOP

Recommend the use of a drip loop as below so the water can
not run along the power cord even possibly reach the
electrical outlet and plug.
WARNING
Keep the extension cord clear of the working area. Position
the cord so that it will not get caught on lumber, tools, or
other obstructions while you are working with a power tool.
Failure to do so can result in serious personal injury.
4

UNPACK THE MACHINE

WARNING
Make sure that you correctly assemble the machine before
use.
WARNING
• If the parts are damaged, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
English
14
7
5

INSTALL THE UPPER PANEL

2
23
1. Aligh the screw sleeves of the front panel (2) with the
screw holes on the upper handle (23).
2. Tighten them with a Phillips screwdriver (not included).
6 INSTALL THE SPRAY GUN
HOLDER
3
1. Aligh the screw sleeves of the spray gun holder (3) with
the screw holes on the upper handle.
2. Tighten them with a Phillips screwdriver (not included).
7
EN