Start The Machine; Stop The Machine; Thermal Relief Valve Function; Maintenance - GreenWorks Pro GPW2500C Manual Del Operador

1. Place the pressure washer upright on a flat surface.
2. Open the cap on the detergent tank (6).
3. Pour detergent into tank (6).
4. Reinstall cap.
Do not let detergent dry on the surface to prevent streaks.
11.5

START THE MACHINE

CAUTION
Do not operate without the water supply connected.
CAUTION
Before you start the machine:
1. Turn the water supply on.
2. Pull the gun trigger to release air pressure.
3. If a stable stream of water come into view, release the
spray gun trigger.
1. Connect the machine to the power supply.
2. Press down on the ON/OFF switch (10) once to set the
power switch to the "ON" ( | ) position.
3. Turn the water supply on.
4. Pull the spray gun trigger.
11.6

STOP THE MACHINE

1. Release the spray gun trigger.
2. Press down on the ON/OFF switch, once again, to set the
power switch to the "OFF" (O) position.
WARNING
If you do not use the machine：
• Stop the machine.
• Turn the water supply off.
• Disconnect the power cord from the outlet.
• Pull the spray gun trigger to release the remaining
pressure from the machine.
• Engage the trigger safety lock-out on the spray gun.
NOTE
10
English
11.7 THERMAL RELIEF VALVE
FUNCTION
The thermal relief valve is a thermal protector for the pressure
washer pump. It protects the pump from damaging heat that
builds up while in recirculation/ bypass mode. Opening
temperature is 140°F. The valve will reset automatically once
the pump relives the excess heat.
12

MAINTENANCE

Before maintenance, make sure that you
• stop the machine.
• wait until all the moving parts stop.
• disconnect the plug from the power source.
Do not use strong solvents or detergents on the plastic
housing or components.
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Replace the power cord by an approved service center.
12.1

SPRAY TIP MAINTENANCE

Never point the spray wand at your face.

12.1.1 REMOVE THE SPRAY TIP

18
①
②
1. Pull back the quick-connect collar (19) on the spray wand
(4).
2. Remove the spray tip (18) from the spray wand (4).
11
WARNING
WARNING
WARNING
WARNING
WARNING
19
4
EN