Clean The Spray Tip; Adding Lubricating Oil; Transportation And Storage; Move The Machine - GreenWorks Pro GPW2500C Manual Del Operador

EN

12.1.2 CLEAN THE SPRAY TIP

20
18
1. Use a straight paper clip or cleaning tool (20) to clean the
spray tip.
2. Flush and clean the unwanted materials out of the spray
tip (18) with the garden hose (17).
3. Install the clean spray tip (18) back into the spray wand
(4).
18
②
Click
12.2

ADDING LUBRICATING OIL

This machine is a professional pressure washer. For better
and longer use, you should add lubricating oil first after 50
hours' use. After first oil addition, you only need to add
lubricating oil every 200 hours.
Only use the recommended lubricating oil: S15W-40.
1. Clean the grease on crankcase.
2. Insert a funnel into the lubricating oil port (13).
3. Add the lubricating oil (240-260ml every time) into the
port.
To clean the crankcase grease for the first time, it is
recommended to use diesel oil into the crankcase, shake the
whole machine shakes slightly, and then pour out the diesel
oil. And then add lubricating oil.
19
①
③
WARNING
WARNING
NOTE
English
13
13 TRANSPORTATION AND
STORAGE
Disconnect the power cord and watter supply hose before

transportation and storage.

13.1

MOVE THE MACHINE

• Point the spray wand in a safe direction.
• Only hold the machine with the handgrip.
13.2

STORE THE MACHINE

Make sure that the spray gun, the high pressure hose and the
pump are dry.
Make sure the machine is out of the reach of children.
Use a recommended pump protector to prevent cold
weather damage during storage in winter.
• Disconnect the garden hose from machine.
• Wind the power cord and the high pressure hose.
• Clean housing and the plastic components with a moist
and soft cloth.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, follow these steps/
instructions:
12
WARNING
WARNING
WARNING
NOTE