Festool ETS EC 125/3 EQ Manual De Instrucciones Original página 7

Ocultar thumbs Ver también para ETS EC 125/3 EQ:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Constant speed
The preselected motor speed is kept constant
through electronic control. This ensures a uni­
form cutting speed even when under load.
Speed reduction in the event of high vibrations
If high vibrations and oscillations occur at the
power tool, e.g. with the use of an interface pad,
the speed is automatically reduced in order to
protect the power tool and the user.
Temperature cut-out
To avoid the motor overheating, the power con­
sumption is limited at an excessive motor tem­
perature. If the temperature continues to rise,
the power tool switches off. and can only be
switched on again once the motor has cooled
sufficiently.
8.2
Setting and adjusting the speed
The speed can be set [1-2] between 6000 and
10000 min
-1
using the adjusting wheel.
This enables you to optimise the sanding speed
to suit the material (see chapter 9).
8.3
Replacing the sanding pad [3]
An optimal work result can only be ach­
ieved using original accessories and con­
sumables. The use of non-original accessories
or consumables invalidates the right to claim
under warranty.
Warning! do not perform any structural
changes in the open interior space of the
machine when the sanding pad is dismantled.
Health risk: Fitting sanding pads of in­
correct size causes excessive vibration of
the machine.
Tuned to the surface being processed, the ma­
chine can be equipped with three sanding pads
of different hardnesses.
Hard: Coarse and fine sanding on surfaces.
Sanding edges.
Soft: Universal for coarse and fine sanding, for
flat and convex surfaces.
Extra-soft: Fine sanding of moulded parts,
arches, radii. Do not use on edges.
8.4
Attaching sanding accessories using
StickFix [3B]
The suitable StickFix sandpaper and StickFix
sanding cloth can be attached quickly and sim­
ply to the StickFix sanding pad.
► Affix the self-adhesive sanding accesso­
ry [3-1] to the sanding pad [3-2].
In the case of a weakening adhesive ef­
fect of the StickFix surface, the sanding
pad accessories, in particular those which are
not yet touching the workpiece, may come
loose from the sanding pad and cause injuries.
Replace the sanding pad!
English
7

Publicidad

Tabla de contenido
loading

Tabla de contenido