3.2
Intended use
Dräger X-am 2800 is a portable gas detector for continuous monitoring of the
concentration of several gases in the ambient air within the working area and in
explosion-hazard areas.
3.3
Approvals
A copy of the name plate, the declaration of conformity, and the sensor data
relevant for measurement purposes are provided in the enclosed supplementary
documentation (part no. 9300308) or at www.draeger.com/ifu.
The name plate on the gas detector must not be concealed.
FCC:
The radio license information can be found in the information on the device. For
further information see: "Opening device information", page 50.
3.4
GPL (General Public License)
Depending on their configuration, Dräger products which use software use Open
Source software. This is regularly subject to special licensing conditions which
take precedence in their scope. Several Open Source software licensing
conditions may apply in a single Dräger product, which then apply respectively
to the associated software components. Further information on the Open Source
software used in this products is available on the following Internet page: www.
draeger.com/opensource.
4
Operation
4.1
Symbol explanations
Symbol Explanation
Bump test
Fresh air calibration
Single-gas calibration
Mixed gas calibration
Measurement range exceeded
®
X-am
2800
|
Operation
en
41