Installation - Adding Flip-Down Hardware - Permobil BodiLink Head Support Operación Manual

INSTALLATION - ADDING FLIP-DOWN HARDWARE

Adding the Flip-Down Hardware to PT Hardware
1 Remove the screw (A) and the safety washer (B) from the taper insert (C). Separate the link (D) and the stem (E).
2
Align the Flip-Down Hardware (F) with the link (D). Make sure the lever (G) is on the right-hand side of the hardware
assembly.
3
Place the existing taper insert (C) halves (countersunk side first) in the end of link (D).
- Make sure that the square ends are aligned inside for a low-profile fit in the joint.
- The countersunk side of all taper inserts (C) should face the same direction on the hardware so that the screws (A)
are all on the same side.
4
Insert the screw (A) and the safety washer (B) into countersunk side of taper insert (C) and tighten. Firmly hold the
threaded side of the taper insert while tightening.
B
A
BodiLink Head Support Operation Manual
D
C
A
C
B
E
13
D
B C
G
A
F
D
G
F