Step 4: Entering The Area Code - Sony SPP-ID975 Manual De Instrucciones

Step 4: Entering the area code (continued)
5
Press Jog Dial.
"ENTER AREA CODE" appears on the display.
6
Enter three digits of the local area code using the dialing
keys.
7
Press (PGM).
You will hear a long confirmation beep.
Notes
• If the local area code is already entered, it appears on the display in step 5. To
enter a different local area code, see "To change the local area code" below.
• Do not allow more than 20 seconds to elapse between each step of the
procedure.
Tips
• You may press Jog Dial instead of (PGM) in step 7.
• To check the current local area code, perform steps 1 to 5. The local area code
appears on the display for about 20 seconds.
To change the local area code
1
Perform steps 1 to 5 on page 15.
The current local area code appears on the display.
2
Turn Jog Dial down to erase the current local area code.
3
Enter a new local area code using the dialing keys.
4
Press (PGM).
You will hear a long confirmation beep.
To erase the local area code
You can erase the local area code. Perform steps 1 and 2 above, then
press (PGM).
The local area code will be erased, and you will hear a long
confirmation beep.
16 US
Getting Started