Milnor MilTouch MWF27Z8 Serie Guía Del Operario página 12

Table of Contents
4.1.2. Messages that Can Occur on MilTouch-EX
4.1.2.1. Brake Pads Worn (20)
4.1.2.2. Control on Clean Side (21)
4.1.2.3. Check Balance System/Excursion Switch (23)
4.1.3. Messages that Can Occur on Automatic Load/Discharge
™
MilTouch-EX
4.1.3.1. Brake Pads Worn (16)
4.1.3.2. Loading Aborted (19)
4.1.3.3. Discharge Aborted (20)
4.2. Inputs and Outputs for the MilTouch
BICLUT01)
4.2.1. Outputs
4.2.1.1. MilTouch 3 (WUMTGUIA 3.x)
4.2.1.2. MilTouch 2 (WUMTGUIA 2.x)
4.2.2. Inputs
4.3. Components of the MilTouch
(Document BICLJT01)
4.3.1. Processor board (P/N: 08BHPAR91_)
4.3.2. Input/output board (P/N: 08BHF120A_)
4.4. Out-of-balance Detection and Balancing for Washer-
extractors
(Document BICLUF02)
®
4.4.1. MilTouch Models
4.4.2. MilTouch-EX ®
4.4.2.1. If the Next Operation is an Intermediate Extract
4.4.2.2. If the Next Operation is a Final Extract
4.4.2.2.1. If the Excursion Switch Trips
4.4.2.2.2. If the Excursion Switch Does not Trip
®
4.4.3. MilTouch-EX
4.4.3.1. If the Next Operation is an Intermediate Extract
4.4.3.2. If the Next Operation is a Final Extract
4.4.3.2.1. If the Excursion Switch Trips
4.4.3.2.2. If the Excursion Switch Does not Trip
4.5. Out-of-Balance Detection System
4.5.1. Requirements
PELLERIN MILNOR CORPORATION
Sections
Models Only
™
Controller
™
Controller Circuit Boards
Models Other than 72046M5K
Model 72046M5K
(Document BICLUT04)
Figures, Tables, and Supplements
™
Models Only
Figure 32: Board Identification
(Document
Table 11: Output V3 Function and V3
Connection
Table 12: Output Function and Connection
Table 13: Speed Signals from Outputs
Figure 33: Output Indicator Position and
Label
Table 14: Input Function and Connection
Figure 34: Input Indicator Position and
Label
Figure 35: 08BHPAR91_, Revision C
Figure 36: 08BHF120_, Revision B
Figure 37: MilTouch Home Screen
Figure 38: MilTouch SD Card
8