Milnor MilTouch MWF27Z8 Serie Guía Del Operario página 32

Chapter 2. How to Update the Machine Software
• Remove the manual inverter control outputs display.
• Prevent the removal of a wash step if the result would be two consecutive extract steps.
• Prevent the duplication of an extract step. This prevents two consecutive extract steps.
• Correct the behavior of the Formula Search function on the Home screen when the formula
list includes inactive formulas.
• Improve the stability of the USB import and export functions in multi-operation sessions.
• Allow you to recalibrate the touchscreen.
How do I save my formulas and machine configuration?
2.1.2.
Although this update preserves the programmed formulas and the machine configuration, it is
good practice to keep a backup copy of the formulas and configuration for each machine in your
facility. Use the following procedure to make a backup copy. See
restore my formulas and configuration data?"
1. Turn power to the machine OFF.
2. If there is a flash drive in the USB (universal serial bus) port, remove it. See
Figure 27: Parts Used in This Procedure
.
3. Turn power to the machine ON.
4. Touch the File Transfer button on the Home screen
screen (Figure 29).
Some software versions show a dialog box with a check button
dialog box, confirm that nothing is connected to the USB port. The USB status light on the
File Transfer screen
Figure 28: Confirmation Window
5. Insert the flash drive into the USB port. The USB status light on the File Transfer screen
(Figure 29) will change from red to green.
6. If the status light does not glow green within 5 seconds of inserting the flash drive, remove
the flash drive, wait 10 seconds, then put the flash drive back into the USB port.
PELLERIN MILNOR CORPORATION
to restore the backup data to the machine.
Parts
(Figure 29) is red when the USB port is empty.
28
Section 2.1.4 "How do I
Legend
A. Flash drive (typical)
(Figure 26) to open the File Transfer
(Figure 28). If you see this
Figure 27.