Safety Instructions - Bauknecht BIK5 DH8FS2 ES Guia De Instalacion

SAFETY INSTRUCTIONS

IMPORTANT TO BE READ
AND OBSERVED
Before using the appliance read
these safety instructions .
Keep them for future reference .
These instructions and the
appliance itself provide
important safety warnings, to be
observed at all times .
The manufacturer declines any
liability for failure to observe
these safety instructions, for
inapropriate use of the
appliance or incorrect setting of
controls .
SAFETY WARNINGS
Very young (0-3 years) and
young children (3-8 years) shall
be kept away from the appliance
unless continuously supervised .
Children from 8 years old and
above and persons with reduced
physical, sensory or mental
capabilities or lack of experience
and knowledge can use this
appliance only if they are
supervised or have been given
instructions on safe use and
understand the hazards
involved . Children must not play
with the appliance . Cleaning and
user maintenance must not be
carried out by children without
supervision .
WARNING: The appliance and
its accessible parts become hot
during use, children less than 8
year of age shall be kept away
unless continuously supervised .
WARNING: Avoid touching
heating elements or interior
surface - risk of burns .
Never leave the appliance
unattended during food drying .
If the appliance is suitable for
probe usage, only use the
temperature probe
recommended for this oven .
Keep clothes or other flammable
materials away from the
appliance, until all the
components have cooled down
completely .
Overheated oils and fats catch
fire easily . Always be vigilant
when cooking food rich in fat,
oil or when adding alcohol (e . g .
rum, cognac, wine) - risk of fire .
Use oven gloves to remove pans
and accessories, taking care not
to touch the heating elements .
At the end of cooking, exercise
caution when opening the door,
by letting the hot air or steam
exit gradually before accessing
the appliance .
Do not obstruct hot air vents at
the front of the oven .
PERMITTED USE
CAUTION: The appliance is not
intended to be operated by
means of an external timer or
separate remote controlled
system .
This appliance is solely for
domestic, not professional use .
Do not use the appliance
outdoors .
Do not store explosive or
flammable substances such as
aerosol cans and do not place or
use gasoline or other flammable
materials in or near the
appliance: a fire may break out if
the appliance is inadvertently
switched on .
No other use is permitted
(e . g . heating rooms) .
INSTALLATION
The appliance must be handled
and installed by two or more
persons . Use protective gloves
to unpack and install the
appliance .
Installation and repairs must be
carried out by a qualified
technician, in compliance with
the manufacturer's instructions
and local safety regulations . Do
not repair or replace any part of
the appliance unless specifically
stated in the user manual .
Children should not perform
installation operations . Keep
children away during
installation .
Keep the packaging materials
(plastic bags, polystyrene parts,
etc . ) out of reach of children,
during and after the installation .
After unpacking the appliance,
make sure that it has not been
damaged during transport . In
the event of problems, contact
the dealer or your nearest After-
sales Service .
The appliance must be
disconnected from the power
supply before any installation
operation .
During installation, make sure
the appliance does not damage
the power cable .
Only activate the appliance
when the installation has been
completed .
After installation, the bottom of
the appliance must no longer be
accessible .
Carry out all cabinet cutting
works before fitting the
appliance in the furniture and
carefully remove all wood chips
and sawdust .
Do not obstruct the minimum
gap between the worktop and
the upper edge of the oven .
Only remove the oven from its
polystyrene foam base at the
time of installation .
Do not install the appliance
behind a decorative door - Risk
of fire .
ELECTRICAL WARNINGS
For installation to comply with
current safety regulations, an
omnipolar switch with minimum
contact gap of 3 mm is required
and the appliance must be
earthed .
If the power cable is damaged,
replace with an identical one .
The power cable must only be
replaced by a qualified
technician in compliance with
the manufacturer instruction
and current safety regulations .
Contact an authorized service
center .
EN
29