Bellman & Symfon BE1411 Manual De Usuario página 24

Basic installation – single sound source
1 Remove the battery pull tab to start the unit. Clean the wall with the wet wipe
and remove the protective film from the Velcro.
2 Mount the door transmitter to the left of the doorbell's sound source, as close as
possible. You can also use the supplied screw and plug.
1
46
2
Max 3cm,1.2"
Note: Instead, you can use an
external microphone to pick up
the sound, see the Appendix.
Installation – intercom and electronic doorbell
1 Remove the protective film from the external microphone (sold separately) and
attach it to the intercom's speaker. Connect it to the transmitter.
2
Pull the battery tab to start the transmitter. Clean the wall with the wet wipe and
remove the protective film from the Velcro.
3 Mount the door transmitter to the left of the doorbell's sound source, as close as
possible. Note that the intercom and doorbell must be at least 25 cm, 10"apart
to avoid sound interference.
1 2
Ext. microphone
(sold separately)
DE
DK
EN
3
Max 3 cm, 1.2"
Electronic
Doorbell
47