Bellman & Symfon BE1411 Manual De Usuario página 25

Installation – intercom and mechanical doorbell
If you have an intercom and a mechanical doorbell, you may need two door
transmitters, i.e. one for each sound source.
1 Pull the battery tab to start each door transmitter. Clean the wall surface with
the wet wipe and remove the protective film from the Velcro.
2 Mount one of the door transmitters to the left of the doorbell and the other to
the left of the intercom's speaker, as close to the sound sources as possible.
Max 3cm,1.2" Max 3cm
1 2
48
3
Mechanical Mechanical
Max 3cm,1.2" Max 3cm
doorbell doorbell
Optimizing the doorbell detection
The next step is to teach the transmitter to recognize your doorbell.
1 Press and hold button 1 until the top LED start to blink. Release it to start the
recording.
2 For door buzzers: Press and hold the doorbell for at least 8 seconds.
For door chimes: Press the doorbell at least 8 times.
3 Press button 1 on the transmitter to stop the recording. If the LED lights up in
red, you need to repeat steps 1 and 2. Following the same steps, you can use
button 2 to record the sound of your intercom.
1 2
DE
DK
EN
3
Grön: OK
Green: OK
Röd: Ej OK
Red: Not OK
49