Residual Risks; Setup / Adjustment; Mains Connection; Routing Of The Connecting Cable - Mafell DDF40 Instrucciones De Funcionamiento Y Seguridad

DDF40

3.6 Residual risks

The existing residual risks include:
- Touching the drill bits inside and outside the base plate.
- Touching the drill bits at the rear of the workpiece when drilling through.
- Breakage and ejection of the drill bits or parts of the drill bits.
- Ejected chips.
- Impaired hearing when working without hearing protection for long periods of time.
- Emission of harmful wood dusts during longer operation without extraction.
4

Setup / adjustment

4.1 Mains connection

Prior to starting up the machine, check to ensure that the mains voltage corresponds to the operating voltage
specified on the rating plate of the machine.

4.2 Routing of the connecting cable

01/2022
Warning
Risk of injury when working with the machine
Even when the machine is used as intended and in compliance with the safety
regulations, there are still residual risks caused by the intended use, which can
have consequences for your health.
➢ Observe the safety instructions and information in these instructions.
Always be extremely careful and cautious when you work with the machine.
➢
Warning
Electric shock when drilling into the connecting cable
The connecting cable can impair safety functions and work functions and
get into contact with the drilling tool. Drilling into the connecting cable of the
machine energizes the metal parts of the machine and causes an electric
shock. There is a risk of injury for the user.
➢ When working, pay attention to the way the connecting cable is
routed.
Never drill into the connecting cable of your machine.
➢
13