Drilling With Accessories - Mafell DDF40 Instrucciones De Funcionamiento Y Seguridad

DDF40
Use the following procedure to use the machine
for drilling:
1. Clamp the workpiece or secure it against
moving.
➢ Use the anti-slip mats provided for this
purpose.
2. Position the machine horizontally or vertically on
the workpiece, as required.
3. Using the spring-loaded stop pins or the
accessories described below, bring the machine
in contact with the outer edges of the workpiece.
Ensure that the contact surfaces of
➢
machine and workpiece are precisely
aligned with each other.
4. Switch on the machine.
5. Push the motor unit forward until it hits the stop.
During this process, hold the machine by the
recessed grips or the rear housing section.
The motor unit moves automatically back
➢
to the home position.
6. Switch off the machine.
Drilling was performed.
✓

5.4 Drilling with accessories

5.4.1 Drilling with lateral guide fence set
The lateral guide fence is suitable for large distances from the edge in carcass processing.
The lateral guide fence consists of 4 parts
- Lateral guide fence (A)
- Roller edge guide (B): For offset carcass
processing with continuous fine adjustment
- Rider (C): To accommodate the roller edge guide
or for ancillary guide fences
- Rider with resilient stop pin (D): To adjust different
edge distances
The lateral guide fence can be inserted on alternate
sides of the base plate.
01/2022
Fig. 18: Drilling with the machine
Fig. 19: Parts of the lateral guide fence
21