Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
K55cc/KSS50cc
Use the following procedure to adjust the
cutting width:
1.
Loosen the wing screws (5) on both sides.
2.
Adjust the roller edge guide.
3.
Tighten the wing screws (5) on both sides.
The cutting width is adjusted.
✓
6
Service and maintenance
MAFELL machines are of a low-maintenance design.
The installed ball bearings are lubricated for life. After a longer period of operation, MAFELL recommends that
the machine be handed over to an authorized MAFELL service workshop for inspection.
6.1 Storage
Clean the machine thoroughly if you will not use it for quite some time. Spray bare metal parts with a rust
inhibitor.
7
Troubleshooting
Some of the most common malfunctions and their causes are listed below. For other malfunctions, please
contact your dealer or MAFELL Customer Service directly.
Malfunction
Machine can not be switched on
01/2022
Warning
Risk of injury from a sudden start of the machine.
There is a risk that the machine starts suddenly due to carelessness when
working with the machine or during troubleshooting. The rotating saw blade can
cause serious injuries.
➢
Determining the causes of existing malfunctions and their elimination
always require increased attention and caution!
Pull out the mains plug before you start troubleshooting!
➢
Cause
Mains voltage missing or too low
Mains fuse defective
Carbon brushes worn out
Fig. 23: Adjusting the cutting width via the roller edge
guide
Elimination
Have the power supply checked
by an electrician
Have fuse replaced by an
electrician
Take the machine to the MAFELL
customer service workshop
27
Publicidad
Tabla de contenido
