Riving Knife - Mafell K55cc Instrucciones De Funcionamiento Y Seguridad

K55cc/KSS50cc

4.6 Riving knife

The riving knife prevents the saw blade from jamming during rip cutting. In addition, the riving knife retracts into
the machine during plunge cuts. This prevents kickback during the sawing process.
The correct distance to the saw blade is shown in the figure.
Use the following procedure to adjust the
distance of the riving knife:
1. Pull out the power plug of the machine.
2. Using the Allen key (B) provided, turn the
screw (17) counterclockwise to loosen it.
3. Move the riving knife along its longitudinal slot
to adjust it.
Do not exceed the maximum distance to
➢
the saw blade (see Fig. 12).
4. Using the Allen key (B), turn the flange screw
(17) clockwise to tighten it.
The riving knife distance is set.
✓
01/2022
Fig. 12: Distance riving knife to saw blade
19