Service And Maintenance; Storage; Transport - Mafell KSS40 18 M bl Instrucciones De Funcionamiento Y Seguridad

5. Switch on the machine.
6. Push the machine steadily forward in working
direction.
7. Switch off the machine after you have finished
machining the workpiece.
8. Pull the machine back to the starting position
while it remains on the workpiece.
This ensures that the lower movable guard
➢
closes completely. A yellow sticker on the
guiding device indicates the starting
position. The machine is in the safe
starting position when you pull it back
behind the mark (in the direction of SAFE).
9. Remove the machine from the workpiece when
it is in this position.
Miter cut with the guiding device is
✓
completed.
6

Service and maintenance

MAFELL machines are of a low-maintenance design.
The installed ball bearings are lubricated for life. After a longer period of operation, MAFELL recommends that
the machine be handed over to an authorized MAFELL service workshop for inspection.

6.1 Storage

Clean the machine thoroughly if you will not use it for quite some time. Spray bare metal parts with a rust
inhibitor.

6.2 Transport

When you ship the rechargeable batteries, ensure that certain special requirements are satisfied with regard to
packaging and labeling. The contained Li-ion batteries are subject to the requirements of the regulations for
hazardous materials.
Ship rechargeable batteries only when their housings are undamaged.
Prior to shipping, stick non-conductive tape (e.g. insulating tape) across the battery terminals and pack the
batteries such that they cannot move inside the packaging.
Please ensure that you observe any further national regulations too.
30
Fig. 27: Perform miter cut with the guiding device
KSS40 18 M bl
01/2022