Fm Radio Operation - Lenco CD-400GY Manual De Usuario

OTHER DAB+ MENU OPERATION
Press and hold the MENU button to access the menu control. Then press the
options as described below.
Dynamic Range Control (DRC)
DRC can make quieter sounds easier to hear when the unit is used in a noisy environment. The DRC level of a
broadcast is set by the broadcaster and transmitted with the service. Changing the DRC value on your unit enables
you to apply a scaling factor to this level.
There are three levels of compression:
DRC high:
DRC low:
DRC off:
1. Press and hold the MENU button to access the menu control.
2. Press the or
3. Press the or
4. Press the MENU button repeatedly to exit the menu control.
Note:
- Not all DAB+ broadcasts are able to use DRC function. If the broadcast does not support DRC then the DRC
setting in the unit will have no effect.
- After you have adjusted the DRC level the sound may be louder.
Prune
This function removes invalid stations.
1. Press and hold the MENU button to access the menu control.
2. Press the or
3. Press the or
4. Press the MENU button repeatedly to exit the menu control.

FM RADIO OPERATION

Auto Scan
1. Turn on the unit in FM mode.
2. Press and hold the SCAN button to start auto-scanning and saving the available stations (max. 30 storage).
Manual Scan
1. Press the or
2. Alternatively press and hold the
Maximum compression as sent with the transmitted service
Set to 1/2 that of the sent transmitted service
No compression
button until "DRC" is displayed and then press the ENTER button.
button to select the DRC value and then press the ENTER to confirm.
button until "Prune" is displayed and then press the ENTER button.
button to select "Yes" and then press the ENTER button to prune the unit.
button repeatedly to tune to a different frequency, 0.05MHz per step.
or button to automatically search to the next available station.
15
or button for different