Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY FUNCTIONS
FUSE CHECK/REPLACEMENT/RESET
EMERGENCY PUSH-BUTTON
DRIVER'S SEAT MICROSWITCH
Lamellar fuse check/replacement
Fuse check
06/2009
1.
Drive the machine on a level ground and engage the
parking brake.
2.
Turn the ignition key (72) to "0".
3.
Open the hood (7).
4.
Disconnect the battery connector (46).
1.
Remove the fuse box cover (51).
2.
Check/replace the relevant fuse among the following (Fig.
19):
•
(A): F1 main fuse (key circuit) (15 A)
•
•
(C): F3 manual vacuum system fuse (40 A) (optional)
•
(D): F4 vacuum system motor fuse (30 A)
•
(E): F5 horn and pivoting light fuse (10 A)
•
(F): F6 working light fuse (10 A) (optional)
3.
Remove the electrical component box cover (55).
4.
Check/replace the following fuse (Fig. 20):
(e): FT drive system fuse (70 A)
1.
Check one of the following fuses (Fig. 19) for deactivation:
(G): FA main broom motor fuse (30 A)
(H): FB side broom motor fuse (10 A)
Reset any deactivated fuse, when the component that
caused deactivation has fully cooled down.
2.
Close the hood (7).
The machine is equipped with the following safety functions.
It is located in an easily accessible position (82). It has to be pressed in case of emergency, to stop all the machine functions.
It is located inside the driver's seat and it does not allow the machine drive system to operate if the operator is not seated on the
driver's seat.
(B): F2 filter shaker motor fuse (25 A)
INSTRUCTIONS FOR USE
1464035000 - Terra™ 4300B
Figure 19
Figure 20
A
B
C
ENGLISH
G
H
D
E
F
A
23
P100348
P100349
Publicidad
Tabla de contenido
